Is it safe to drive on a slow puncture to reach a tyre fitter? +
If the tyre is only slightly low and you can maintain safe control of the vehicle, you can drive a short distance at reduced speed — no more than a few miles at 20–30mph. Check the tyre regularly as you drive. If the tyre is visibly flat, the sidewall is bulging, or the car feels unstable, do not drive at all. Call a mobile tyre fitter to come to your location instead.
What should I do if I get a flat tyre on the motorway? +
Pull onto the hard shoulder as far left as possible, switch on your hazard lights, and exit the vehicle from the passenger side away from traffic. Do not attempt to change a tyre on the motorway hard shoulder — it is extremely dangerous. Move behind the crash barrier if there is one, then call a mobile tyre fitter or breakdown service. If you are on a smart motorway with no hard shoulder, stop in an emergency refuge area.
What are run-flat tyres and can any fitter work on them? +
Run-flat tyres have reinforced sidewalls that support the weight of the car even with no air pressure, allowing you to drive up to 50 miles at 30mph after a puncture. They require specialist fitting equipment and a TPMS reset after replacement. Not all garages can work on run-flat tyres, but most professional mobile fitters and tyre centres are fully equipped. Run-flat tyres are typically 20–40% more expensive than standard equivalents.
Are winter tyres worth it in the UK? +
Winter tyres use a softer rubber compound and a different tread pattern that provides significantly better grip below 7°C — not just in snow, but on cold, wet roads. In independent tests, winter tyres reduce braking distances by up to 11 metres compared to summer tyres in cold conditions. If you regularly drive in rural areas, hills, or northern parts of the UK, they can be a worthwhile investment from October to March.
Can a tyre blowout be repaired or does it need replacing? +
A tyre that has suffered a blowout almost always needs replacing. The internal structure of the tyre is usually destroyed by the sudden loss of pressure and the impact damage that follows. Even if the tyre appears intact, the sidewall and carcass will have been compromised. A tyre fitter can inspect it, but in the vast majority of cases a new tyre is the only safe option.
How long does it take to fit a new tyre? +
A single tyre change typically takes 15 to 30 minutes, including removing the old tyre, fitting and balancing the new one, and torquing the wheel nuts to the correct specification. If you are having all four tyres replaced, expect the job to take around 45 minutes to an hour. Mobile fitters work to the same timescales as a garage.