What is the difference between budget and premium tyres? +
Premium tyres from manufacturers like Michelin, Continental, and Bridgestone consistently outperform budget alternatives in independent braking tests — often stopping several metres shorter in wet conditions. They also tend to last longer, produce less road noise, and offer better fuel economy. For a typical family car, the difference between a budget and premium tyre is usually £25–£40 per tyre, which most drivers recoup through longer tread life.
Are part-worn tyres safe to buy? +
Part-worn tyres carry significant risks. While they are legal to sell in the UK, studies have found that a large proportion fail to meet legal standards — many have been previously repaired improperly, have internal damage not visible from the outside, or are close to the legal tread limit. The small saving is rarely worth the risk. New budget tyres from reputable brands often cost only £15–£25 more and come with a full warranty.
What is the legal minimum tyre tread depth in the UK? +
The legal minimum tread depth in the UK is 1.6mm across the central three-quarters of the tyre, around its entire circumference. However, most motoring organisations recommend replacing tyres at 3mm, as braking performance drops significantly below this level. Driving on tyres below 1.6mm carries a fine of up to £2,500 and 3 penalty points per illegal tyre — so four bald tyres could mean a £10,000 fine and 12 points.
Are winter tyres worth it in the UK? +
Winter tyres use a softer rubber compound and a different tread pattern that provides significantly better grip below 7°C — not just in snow, but on cold, wet roads. In independent tests, winter tyres reduce braking distances by up to 11 metres compared to summer tyres in cold conditions. If you regularly drive in rural areas, hills, or northern parts of the UK, they can be a worthwhile investment from October to March.
What happens during an MOT tyre check? +
During an MOT, the examiner checks that all tyres are the correct size and speed rating for the vehicle, that tread depth is at least 1.6mm across the central three-quarters, that there are no cuts, bulges, or exposed cords, and that tyres on the same axle are of the same type (e.g. not mixing radial and cross-ply). Incorrect tyre pressure is not an MOT failure but the examiner may issue an advisory.
What are run-flat tyres and can any fitter work on them? +
Run-flat tyres have reinforced sidewalls that support the weight of the car even with no air pressure, allowing you to drive up to 50 miles at 30mph after a puncture. They require specialist fitting equipment and a TPMS reset after replacement. Not all garages can work on run-flat tyres, but most professional mobile fitters and tyre centres are fully equipped. Run-flat tyres are typically 20–40% more expensive than standard equivalents.